Bissell robot vacuum "SpinWave bumper stuck or trapped" (2 beeps): what it means and the fix
Works for Bissell SpinWave (2859, 3115 and 2931 families), EV675 (2503), SmartClean (1605) and DigiPro (2142) robots.
What it means: The bumper is stuck or the robot is trapped.
Quick fix: Turn the robot off.
Fix it in 4 steps
- Turn the robot off.Do this before you touch the wheels, brushes or bumper.Done?
- Remove debris from the bumper.Done?
- Tap or press the bumper several times so it moves freely.Done?
- Press START/PAUSE to clear the error, then press it again to resume cleaning.Did it work?
Fixed when: The bumper moves freely and the robot resumes cleaning.
Great, it is fixed. Bookmark this page in case it comes back.
Still showing SpinWave bumper stuck or trapped?
The bumper stays stuck. Contact Bissell Consumer Care. Contact Bissell support. Have the serial number ready: Model number is on the label on the underside of the robot.. Warranty: EV675: 1 year limited warranty per Bissell's product page. Check the warranty guide for your model.. Bissell support →
Parts that fix this
Why it happens
- Debris jammed in the bumper
- Robot trapped
Other Bissell robot vacuum errors
1 beepSpinWave 1 beep, flashing red›1 beepSpinWave wheel stuck›1 beepSpinWave water pump failure›2 beepsSpinWave side brushes stuck›2 beepsSpinWave trapped on carpet in mop mode›3 beepsSpinWave front caster error›3 beepsSpinWave roller brush stuck›3 beepsSpinWave low water›3 beepsSpinWave tank motor failure›EV675 flashing red›EV675 solid red, 3 beeps›EV675 breathing blue›E1SmartClean E1›E2SmartClean E2›E3SmartClean E3›E4, E5SmartClean E4 or E5›E6SmartClean E6›LoSmartClean Lo›E5DigiPro E5›All 21 Bissell robot vacuum codes →